hardware
-
PC/104 and the Rogers Adoption Curve
I’m certain that there were some project managers in the early 1990s who were hesitant to design with PC/104. “We’ll stick to the older, proven specifications, thank you very much.” Thankfully, there were plenty of early adopters – engineers and designers who saw the value of a stackable architecture, the elimination of the backplane, and [...]
-
PC/104: The small form factor doing big things
Writing about PC/104 can be challenging: If you’re just talking about the form factor, there’s not a whole lot of new material to cover. In fact, if you’re reading this in a printed magazine, it’s likely that you already know about PC/104. But for the sake of those who don’t know – if you’re a [...]
-
Small-form-factor solutions revolutionize system architectures
Radar, communications, and SIGINT [signals intelligence] systems have traditionally combined sensor processing, data conversion, and signal processing hardware within single enclosures or equipment racks. Analog signals for antennas, transducers and other sensors were connected through cables, often causing loss and interference along the way. However, enabled by new data converter and field-programmable gate array (FPGA) technology and evolving open embedded computing standards, system designers can now deploy small-form-factor (SFF) subsystems at each sensor site for distributed signal acquisition and preprocessing. Digitized signals are then delivered through optical cables, providing higher signal quality over longer connection distances while reducing size, weight, cost, and maintenance.
-
Medical devices with ultrasound-guided navigation ease needle placement for healthcare professionals
"Stop – you have reached your destination." With increasing traffic in healthcare centers, clinics face many challenges. Ultrasound-guided devices can allow clinicians without ultrasound expertise to easily integrate sonography into their workflow for needle placement, cannulas, and other invasive medical devices and procedures. Battery-powered, high-computing-power portable imaging systems allow for increased medical device flexibility, effectiveness, and safety.
-
PC/104: Ready solutions
A dozen people sit around a large conference-room table. A few have visitor's badges. Everyone has a smart device of some sort. Many have engineering notebooks and pens. Business cards have been cordially exchanged, and cups of coffee are still too hot to drink. In the middle of the table sits an assortment of printed circuit board assemblies.
-
If wishes were fishes - An accidental computer scientist goes embedded
Is it even still relevant to discuss the topic of integrating DSP and FPGA devices in the same hardware?
-
Sensor processing platforms add performance, cut SWaP for the Industrial Internet
As the Industrial Internet demands more out of resource-constrained industrial data acquisition systems, sensor processing platforms are required to add performance while reducing size, weight, and power (SWaP). Rubin Dhillon, Marketing Director of the Embedded Systems division at GE Intelligent Platforms discusses his company’s approach to developing “brilliant machines,” and how off-the-shelf hardware is enabling these sensor platforms for the Industrial Internet.
-
PC/104 Consortium introduces OneBank option for the PCI/104-Express and PCIe/104 specification
OneBank Revision 3.0
-
Transition boards bring COMs to save I/O stacks
In part one of this two-part series, Alexander examines how transitional Computers-On-Module (COMs) can be utilized to extend the life of legacy board stacks.
-
Packaging considerations for Small Form Factor boards
Demanding environments require stalwart packaging even for the most rugged of boards.
Stephen St. Amant, PC/104 Consortium President
Stephen St. Amant, PC/104 Consortium President
Rodger Hosking, Pentek, Inc.
Christian Eder, congatec
Stephen St. Amant, PC/104 Consortium President
Brandon Lewis, Technology Editor
- 1
- 2
